Rigel-systems usb-nSTEP Bedienungsanleitung PDF herunterladen

usb-nSTEP Instructions

Hardware Connection

1) Connect Stepper motor to usb-nSTEP using supplied VOICE cable. Do not

use DATA cables. VOICE cables can be identified by looking at the ends of

the cable. Color of wires are reversed comparing one end to the other.

2) Connect usb-nSTEP to external 12V DC using supplied power cable --

steppers will not work without 12V DC connected

3) Connect usb-nSTEP to PC usb port using supplied USB cable

4) Optional temperature probe plugs into 2.5mm jack next to usb socket on

usb-nSTEP.

BEFORE INSTALLING SOFTWARE

Make sure that your windows account has ADMIN privilege

as ADMIN privilege is required to install drivers in Windows

Software Installation

1) Download and install the ASCOM platform from

http://ascom-standards.org/index.htm

2) Go to http://www.astrogene1000.com/products/gcusb_nstep/gcusb_nstep.htm

3) Click on “INNO Based installer GCUSB-nSTEP ASCOM Driver” and OPEN

4) Double click on the “GCUSB_nSTEP Setup.exe” and run the exe

1 2 3 4

Seite 1

usb-nSTEP Instructions Copyright Rigel Systems 2010 Page 1 of 4 www.rigelsys.com Hardware Connection 1) Connect Stepper motor to usb-nSTEP using su

Seite 2

usb-nSTEP Instructions Copyright Rigel Systems 2010 Page 2 of 4 www.rigelsys.com 5) Accept license agreement and proceed 6) Go Go to http:/

usb-nSTEP Instructions Copyright Rigel Systems 2010 Page 3 of 4 www.rigelsys.com Control Window Position: Where the driver thinks th

Seite 4

usb-nSTEP Instructions Copyright Rigel Systems 2010 Page 4 of 4 www.rigelsys.com Focuser Settings Maximum Position: Value is used by the Absolute Fo

Keine Kommentare

Rigel-systems usb-nSTEP Bedienungsanleitung